The EGW Trijicon RMR Sight Mount for Glock is a direct replacement for your rear dovetail sight that lets you run a modern red dot without gunsmithing. If you're moving from iron sights to a red dot on your Glock, this is the cleanest path: remove the factory rear sight, drop in the EGW mount, and you're ready to attach your optic. Because it uses your existing dovetail, there's zero permanent modification—you can swap back to irons anytime.

Built from 7075 aluminum and finished in matte black hardcoat, this mount is tough enough for duty and carry use. It's sized compact (under 2 inches long and just over an inch wide) so it won't throw off your gun's balance or printing profile. The mount comes with two 6-32 flat head cap screws for your RMR and one set screw for dovetail security, plus all the hardware you need to get running immediately.

This mount is engineered specifically for Trijicon RMR optics and is also compatible with the Holosun HS507C if you're considering alternatives. Note that this design is not compatible with Rock Island 1911s. Installation is straightforward—no modifications to the slide required—and we recommend applying blue Loctite to the mounting screws and torquing them to 15 in/lbs for a secure, permanent bond that won't shake loose on the range or in the field.

The EGW Trijicon RMR Sight Mount for Glock is a direct replacement for your rear dovetail sight that lets you run a modern red dot without gunsmithing. If you're moving from iron sights to a red dot on your Glock, this is the cleanest path: remove the factory rear sight, drop in the EGW mount, and you're ready to attach your optic. Because it uses your existing dovetail, there's zero permanent modification—you can swap back to irons anytime.

Built from 7075 aluminum and finished in matte black hardcoat, this mount is tough enough for duty and carry use. It's sized compact (under 2 inches long and just over an inch wide) so it won't throw off your gun's balance or printing profile. The mount comes with two 6-32 flat head cap screws for your RMR and one set screw for dovetail security, plus all the hardware you need to get running immediately.

This mount is engineered specifically for Trijicon RMR optics and is also compatible with the Holosun HS507C if you're considering alternatives. Note that this design is not compatible with Rock Island 1911s. Installation is straightforward—no modifications to the slide required—and we recommend applying blue Loctite to the mounting screws and torquing them to 15 in/lbs for a secure, permanent bond that won't shake loose on the range or in the field.