Crimson Trace LaserSaddle Laser Sight for Mossberg 500/590 Series & Shockwave Shotguns - Matte FinishCrimson Trace$221.49
Loading...
Loading...
Loading...
Loading...
Crimson Trace
The Crimson Trace LS250 LaserSaddle is a red laser sight purpose-built for Mossberg 500, 590, and 590 Shockwave shotguns in 12 and 20 gauge. If you run a Mossberg pump shotgun and want fast, intuitive target acquisition—whether you're hunting upland game, running clay courses, or training for defensive scenarios—this laser sight mounts directly to the receiver saddle with a clean, rugged profile. The 5mW red laser (633nm wavelength) gives you an instantly visible aiming point in indoor and low-light conditions, without eating into your sight picture or requiring you to shoulder the gun differently.
The LS250 uses multiple ambidextrous pressure-activation pads, so you can paint targets from either hand or during awkward gun handling. A dedicated Master On/Off switch lets you kill power completely when the gun goes back in the safe—no accidental drain, no guesswork. Windage and elevation are user-adjustable, so you can dial it in to your point of impact in minutes. The laser ships pre-sighted at 50 feet and comes with two CR2032 batteries; expect about 3 hours of runtime before you need to swap them. Installation is user-handled—no gunsmith required—but your receiver must be drilled and tapped (check your specific Mossberg model to confirm). The black polymer body is tough and lightweight, and Crimson Trace backs it with a three-year full warranty.
One note: the LS250 fits 12 and 20 gauge receivers only; it will not work with .410 bore shotguns.
| Brand | Crimson Trace |
| Model | LS250 LaserSaddle |
| Laser Type | 5mW Red (633nm) |
| Finish | Black |
| Fits Mossberg Models | 500, 590, 590 Shockwave (12 and 20 gauge only) |
| Compatibility Note | Does not fit .410 bore; requires drilled and tapped receiver |
| Material | Polymer |
| Activation | Pressure activated (ambidextrous) |
| Adjustment | User-adjustable windage and elevation |
| Battery Type | Two CR2032 (included) |
| Battery Life | Approximately 3 hours |
| Factory Sighting | 50 feet |
| Dot Size at 50 feet | Approximately 0.50 inch |
| Installation | User installed |
| Warranty | Three-year full warranty |
The LS250 LaserSaddle fits Mossberg 500, 590, and 590 Shockwave shotguns in 12 gauge and 20 gauge only. Your receiver must be drilled and tapped to accept the mount. It does not fit .410 bore models. Check your owner's manual or contact Mossberg to confirm your gun has a receiver drilled and tapped for this accessory.
The LS250 comes with the laser sight itself, two CR2032 batteries, and everything you need for user installation. No gunsmith trip required.
You'll get approximately 3 hours of runtime from the two included CR2032 batteries. The Master On/Off switch lets you shut it down completely between uses to preserve battery life.
Yes. The LS250 is user-adjustable for both windage and elevation, and it ships pre-sighted at 50 feet. You can dial it in to your gun's point of impact without any tools or professional help.
Crimson Trace
The Crimson Trace LS250 LaserSaddle is a red laser sight purpose-built for Mossberg 500, 590, and 590 Shockwave shotguns in 12 and 20 gauge. If you run a Mossberg pump shotgun and want fast, intuitive target acquisition—whether you're hunting upland game, running clay courses, or training for defensive scenarios—this laser sight mounts directly to the receiver saddle with a clean, rugged profile. The 5mW red laser (633nm wavelength) gives you an instantly visible aiming point in indoor and low-light conditions, without eating into your sight picture or requiring you to shoulder the gun differently.
The LS250 uses multiple ambidextrous pressure-activation pads, so you can paint targets from either hand or during awkward gun handling. A dedicated Master On/Off switch lets you kill power completely when the gun goes back in the safe—no accidental drain, no guesswork. Windage and elevation are user-adjustable, so you can dial it in to your point of impact in minutes. The laser ships pre-sighted at 50 feet and comes with two CR2032 batteries; expect about 3 hours of runtime before you need to swap them. Installation is user-handled—no gunsmith required—but your receiver must be drilled and tapped (check your specific Mossberg model to confirm). The black polymer body is tough and lightweight, and Crimson Trace backs it with a three-year full warranty.
One note: the LS250 fits 12 and 20 gauge receivers only; it will not work with .410 bore shotguns.
| Brand | Crimson Trace |
| Model | LS250 LaserSaddle |
| Laser Type | 5mW Red (633nm) |
| Finish | Black |
| Fits Mossberg Models | 500, 590, 590 Shockwave (12 and 20 gauge only) |
| Compatibility Note | Does not fit .410 bore; requires drilled and tapped receiver |
| Material | Polymer |
| Activation | Pressure activated (ambidextrous) |
| Adjustment | User-adjustable windage and elevation |
| Battery Type | Two CR2032 (included) |
| Battery Life | Approximately 3 hours |
| Factory Sighting | 50 feet |
| Dot Size at 50 feet | Approximately 0.50 inch |
| Installation | User installed |
| Warranty | Three-year full warranty |
The LS250 LaserSaddle fits Mossberg 500, 590, and 590 Shockwave shotguns in 12 gauge and 20 gauge only. Your receiver must be drilled and tapped to accept the mount. It does not fit .410 bore models. Check your owner's manual or contact Mossberg to confirm your gun has a receiver drilled and tapped for this accessory.
The LS250 comes with the laser sight itself, two CR2032 batteries, and everything you need for user installation. No gunsmith trip required.
You'll get approximately 3 hours of runtime from the two included CR2032 batteries. The Master On/Off switch lets you shut it down completely between uses to preserve battery life.
Yes. The LS250 is user-adjustable for both windage and elevation, and it ships pre-sighted at 50 feet. You can dial it in to your gun's point of impact without any tools or professional help.